Table of Contents
Advertisement
I s s u e 1 . 0 , A p r i l 2 0 0 6
multi-level UDP and TCP session chaining. You must set Enable Session Chaining
to Allow if you want this to work.
Binary Address Replacement; select Allow or Block depending on whether you want to use
binary address replacement on an existing trigger.
Address Translation Type; specify what type of address replacement is set on a trigger. You must
set Binary Address Replacement to Allow if you want this to work.
3. Once you have configured the trigger, click on Apply. The Firewall Trigger Configuration
page is displayed, containing details of the trigger that you have just configured.
4. Each trigger displayed in the Firewall Trigger Configuration page has a Delete hyperlink
assigned to it. To delete a trigger, click on this link, then at the confirmation page, click on the
Delete button. The Firewall Trigger Configuration page is displayed and details of the deleted
trigger have been removed. There are two hyperlinks on the page:
a To add a new trigger, click on New Trigger.
b To display the Security Interface Configuration page, click on Return to Interface List.
These actions have the same effect as typing the following CLI commands:
security add trigger
security list triggers
security set trigger endport
security set trigger startport
security set trigger multihost
security set trigger maxactinterval
security set trigger sessionchaining
security set trigger security set trigger
UDPsessionchaining
security set trigger binaryaddressreplacement
security set trigger addressreplacement
©2006 Charles Industries, Ltd.
All rights reserved. Printed in United States of America.
The availability of features and technical specifications herein subject to change without notice.
82
Section 364-180-N02
Advertisement
Table of Contents
