Figure 6-29 Web Tool - Ip Routes: Create Ip V4Route Page; Figure 6-30 Web Tool - Ip Routes: Edit Routes Page - Charles 3641-80 User Manual

I s s u e 1 . 0 , A p r i l 2 0 0 6
Figure 6-29
2. Enter the destination, gateway and netmask for your route. You can also specify the cost and
the interface to apply it to. Use the name of your WAN or LAN interface. Click OK, then the
"Edit Routes" page will appear and show the configured route. There is a Valid indicator
showing the status of each route. If the LED color is red, the route is invalid because of the
wrong interface name or the same Destination/Netmask as some already existing route. If the
LED color is green, the route is a valid route.
NOTE: To set rip host route or rip poison, you can only do the setting by CLI
commands. You cannot access these two IP routes features through Web
configuration.
©2006 Charles Industries, Ltd.
All rights reserved. Printed in United States of America.
The availability of features and technical specifications herein subject to change without notice.
Web Tool – IP routes: Create Ip V4Route page
Figure 6-30 Web Tool – IP routes: Edit Routes page
53
Section 364-180-N02