Activation - Uplink 5200 Installation & User Manual

ACTIVATION

1. Activate the unit on the Uplink Dealer Portal with the full ten digit unit serial number.
The unit serial number begins with "B" and is found on the box label and device label.
a. Enter the unit name and tracking number for your reference
b. Enter the Panel make and model connected to the unit
c. Select the panel test interval: none/daily/weekly
d. Select service class: Standard or Two-way voice Verification System
e. Select Central Station receiver type: Contact ID dial-up or IP
NOTE: MUST BE CONTACT ID DIAL UP FOR TWO-WAY VOICE.
f. Enter a Central Station Receiver Phone Number
• This will override any receiver phone number in the alarm panel
• This number will be used if Contact ID over IP fails
g. Enter the Central Station account number
• This will override any in the alarm panel
h. Internet Connection Fault Notifications
• Select Notify on Internet Connection Lost: Yes/No
• Select Notify on Connection Restoral: Yes/No
2. To test the unit's registration status, select Send Status Request Signal from the "Test"
tab on the Uplink Dealer web site. View device registration status.
BROADBAND
ALARM COMMUNICATOR
6