Advertisement
S T E P
4
Be careful to assemble all components
in the sequence they are presented.
A.
Place two Weight Stack Risers (27) and two Rubber Donuts (11) onto Main Base Frame (A)
over the two widest openings. Slide two Chrome Guide Rods (M) through the Rubber Donuts (11),
two Weight Stack Risers (27), and into Main Base Frame (A).
B.
Slide fifteen Weight Stack Plates (26) onto the two Chrome Guide Rods (R). Make sure the holes
in the Weight Stack Plates (26) are facing forward as shown.
C.
Connect Top Plate (20) to Selector Rod (21) using:
One 46 (3/8" x 1 1/2" socket head bolt)
D.
Slide Top Plate (20) and Selector Rod (21) onto Guide Rods (M).
NOTE:
Make sure that the Round Bolt (46) is facing forward as shown.
E.
Slide two Shaft Collars (13) onto Guide Rods (M).
F.
Insert two Guide Rods (M) into Top Weight Stack Frame (N).
Attach Top Weight Stack Frame (N) and Flat Plate (70) to Top Frame (E) using:
Two 42 (3/8" x 3" hex head bolt)
Two 51 (3/8" nylon lock nut)
Insert two End Caps (4) into the sides of the Top Weight Stack Frame (N) as shown.
G.
Secure two Shaft Collars (13) into Top Weight Stack Frame (N). Tighten allen head screws in
each Shaft Collar (13).
NOTE:
You should now wrench tighten all bolts and nuts on the main frame unit.
mm
Inch
8
Advertisement
