Advertisement
S T E P
6
Be careful to assemble all components
in the sequence they are presented.
A.
Attach two End Caps (5) to the top and bottom of Back Pad Frame (S).
Attach End Cap (4) to the end of Adjustable Back Pad Frame (T).
B.
Attach Back Pad (U) to Back Pad Frame (S) using:
Two 45 (5/16" x 1 3/4" hex head bolt)*
Two 59 (5/16" spring lock washer)
Two 58 (5/16" washer)
*Do NOT over-tighten these bolts. Tighten these bolts until spring lock washer is flat.
Over - tightening these bolts will cause T - nuts in pads to strip out.
C.
Attach Back Pad Frame (S) to Adjustable Back Pad Frame (T) using:
One 80 (3/8" x 5/8" round allen head bolt)*
One 57 (3/8" x 3/4" O.D. washer)
Insert Pop Pin (78) as shown. Two Oilite Bushings (82) are pre-installed.
*Tighten allen bolt.
D.
Slide Adjustable Back Pad Frame (T) into Back Pad Adjuster (G), and hold in place with Pop Pin (79).
mm
Inch
12
Advertisement
