Advertisement
S T E P
11
Be careful to assemble all components
in the sequence they are presented.
Note:
All Pulleys in this step are 4 1/4" diameter, except where noted in step 10B.
Leave all pulley bolts hand tight until step 13 is completed.
A.
See Diagram 1. Insert small ball end of Low Pulley Cable (67) into the opening in Leg Extension (J),
where pulley (B1) will be installed. Insert Cable (67) into and through Seat Frame (H). Insert
Cable (67) into and through Angled Vertical Frame (D) and pull entire length of Cable (67) through.
B.
See Diagram 2. Install 3 1/2" diameter Pulley (B1), over Cable (67) and into Leg Extension (J) as
shown using:
One 43 (3/8" x 2 3/4" hex head bolt)
Two 15 (pulley spacer)
One 51 (3/8" nylon lock nut)
C.
See Diagram 2. Install Pulley (B2), over Cable (67) and into Seat Frame (H) as shown using:
One 43 (3/8" x 2 3/4" hex head bolt)
Two 15 (pulley spacer)
One 51 (3/8" nylon lock nut)
D.
See Diagram 1. Route Cable (67) through the pulley holder mounted on Main Base Frame (A).
E.
See Diagram 2. Install Pulley (B3), over Cable (67) and into the pulley holder mounted on Main
Base Frame (A) using:
One 44 (3/8" x 1 3/4" hex head bolt)
Two 55 (3/8" washer)
One 51 (3/8" nylon lock nut)
mm
Inch
Low Pulley Cable (67)
Ball Stop End
3730 mm
12' 3"
22
Small Ball End
Advertisement
