Setting The Operating Frequency; Stacked Vfo System - Yaesu FT-818ND Operating Manual

Setting the Operating Frequency

1. In the "SSB/CW/DIG" modes, rotate the
knob to set the frequency. Clockwise rotation
of the knob increases the operating fre-
quency.
2. In the "AM/FM/PKT" modes, rotate the
knob to set the frequency. Clockwise rotation of
the knob increases the operating frequency.
3. You may also use the
DIG" modes. The
in frequency when you want to move across the band in a hurry. You can then use the
knob to make fine frequency adjustments.
4. If you press the
change the operating frequency in 1 MHz steps, allowing very quick frequency excur-
sions. This can be particularly helpful on the VHF and UHF bands.
5. In step 2 above, it was mentioned that tuning in the "AM/FM/PKT" modes is accom-
plished using the
you wish to enable the
6. The synthesizer steps for the
Menu #06 for AM, #30 for FM, and #47 for SSB/CW/Digital. See pages 54, 58, and
61 for details.
The main knob synthesizer's tuning rate (the number of steps per rotation of
the knob) can be adjusted using Menu #33. See page 59 for details.
1. Press the key momentarily, then rotate the
Function Row 1 [A/B, A=B, SPL] appears on the display.
2. Now press the
such VFOs provided on each Amateur band, so you may set VFO-A to the CW sub-
band, and VFO-B to the SSB sub-band, if you like. The operating mode will be pre-
served, along with the frequency information, on each VFO.
knob to adjust the operating frequency in the "SSB/CW/
knob provides faster tuning, ideal for making quick changes
knob momentarily, then rotate the
knob. By default, the
knob in these modes, use Menu #04; see page 54.
knob may be adjusted independently by mode. Use

Stacked VFO System

(A/B) key to toggle between the "A" and "B" VFOs. There are two
Operation
HOME
E
CLAR
A B
C
SEL
knob, you can now
knob is disabled in these modes; if
knob, as needed, until Operating
F
V
M
LOCK
PWR
SQL/RF
DIAL
19