Using.your.Shower
Read the section "Important Safety Information" first.
1.
Switch on electrical supply.
3.
Set to desired position.
5.
Allow 10 - 15 seconds for any temperature adjustments to reach the
handset.
6.
Press STOP button, light on the
button goes out. Shower flow will
continue for a few seconds before
stopping. Isolate power.
Note!.At the end of every shower make sure that the shower head points into the
catchment area. A small amount of water may be retained in the shower handset
after the shower has been turned off. This may drain over a few minutes.
2.
Press the 'Start/Stop' button, light
on the button comes on.
4.
Check water temperature before
entering shower.
7.
Residual water may drain over a
few minutes.
18