Mira escape Installation & User Manual page 15

10.
Turn control to full cold.
13.
Set control to 'III'.
15.
A d j u s t t e m p e r a t u r e a s
required. Flow rate will adjust
automatically.
17.
The shower will purge water from
its tank for a few seconds.
Note!.A slight hissing sound may be heard from the Mira Escape during operation.
High mains water pressure and high shower temperatures will affect the tone. This
is quite normal in use.
11.
Set control to 'II'.
0 - 5 Secs
12.
0 - 0 Secs
The temperature will rise
slightly.
14.
5 - 0 Secs
The temperature will rise further.
16.
Press STOP button, light on the
button goes out. Shower flow will
continue for a few seconds before
stopping. Isolate power.
18.
Residual water may drain over a
few minutes.
5