Fixed Glass Assembly; Install The Mesh; Air Shutter Setting - Heatilator RAVE3012I Owner's Manual

F. Fixed Glass Assembly
WARNING! Risk of Asphyxiation! Handle fi xed glass
assembly with care. Inspect the gasket to ensure it is
undamaged and inspect the glass for cracks, chips or
scratches.
• DO NOT strike, slam or scratch glass.
• DO NOT operate fi replace with glass removed, cracked,
broken or scratched.
• Replace as a complete assembly.
Removing Fixed Glass Assembly
1. Remove the decorative front.
2. Locate the two spring latches that are on the upper
left and right of the fi replace.
3. Use both index fi ngers to release spring latches. See
Figure 14.4.
4. Allow glass to tilt forward. Grasp glass on the upper
right and left sides and lift glass "up" and "out."
Replacing Fixed Glass Assembly
1. Locate glide tabs on lower left and right corners.
2. Grasp glass on upper right and left sides and tilt bot-
tom of glass assembly toward fi replace.
3. Allow of the bottom gasketing of the glass assembly
to touch the face of the fi replace.
4. Put pressure on the glass as you allow the glass
assembly to drop into the two lower glass clips. See
Figure 14.4.
5. Tilt top of glass towards fi replace and engage both
top spring latches
UPPER SPRING LATCH
LOWER GLASS CLIP
Figure 14.4 Fixed Glass Assembly
58
G. Install the Mesh
Deco fronts.
1. Remove fi xed glass assembly as instructed.
2. Place glass assembly into mesh screen such that the
H. Air Shutter Setting
Air shutter settings may be adjusted by a qualifi ed install-
er at the time of installation. The air shutter is set at the
factory for minimum vertical vent run. Adjust air shutter for
longer vertical runs. See Figure 14.5.
• Loosen the 1/4 in. screw.
• Twist shutter to adjust
• Shutter may be open for longer horizontal vent runs.
• Do not close the air shutter more than 1/8 in. for NG
• Tighten the screw.
NOTICE: If the fl ames appear to be orange, open the air
shutter to prevent residue buildup on the glass.
Table 14.1
Heatilator • RAVE3012I • 2269-901 Rev. E • 4/12
The mesh front is included with both the Illusion and
four mesh clips attached to the mesh assembly snap
into the four corresponding slots on the fi xed glass as-
sembly.
or 1/4 in. for LP when glass rock media (shipped with
appliance) is installed. See Table 14.1 below for settings
when optional media (fi ber) stones kit or optional log kit
are installed. See instructions provided with kit.
Figure 14.5 Air Shutter
Air Shutter Settings
RAVE3012I
Glass Rock Media
Media Stones (Optional Kit)
Logs (Optional Kit)
NG LP
1/8 in. 1/4 in.
3/16 in. 5/16 in.