Programming A Memory Channel - Icom ID-800H Operating Manual

6. Set the Repeater Tone Encoder Type and Tone Frequency:
SET●LOCK
a. Press [
b. If necessary, rotate
SET●LOCK
c. Press [
DIAL
d. Rotate [
Example: Set tone frequency to 110.9 for the 146.940 repeater.
TONE●T-SCAN
e. Press [
mode.
You can now operate through the repeater. To ensure you do not lose these settings, you can
save this information to a Memory channel.

Programming a Memory Channel

VFO settings, including the set mode contents such as subaudible tone frequency or offset, can
be programmed into a memory channel.
S.MW●MW
1. Press [ ]
The indicator icon appears on the LCD display.
DIAL
2. Rotate [ ] to select a blank Memory channel in which to program
the current settings. Be certain you select a blank channel so as to not
overwrite any existing channels.
S.MW●MW
3. Press and hold [
beeps will sound indicating the channel was programmed.
Assigning a Memory Channel to a Memory Bank
Each memory channel and the call channel can be programmed with an alphanumeric
name for easy recognition. Names can be a maximum of six characters.
M/CALL●PRIO
1. Press [
select the Memory channel.
SET●LOCK
2. Press [ ]
SET●LOCK
3. Press [ ]
DIAL
4. Rotate [ ] to select the desired Memory bank.
V/MHz●SCAN
5. Press [
Icom ID–800H Mini–Operating Guide by W5JCK, September 2007
] to activate Set mode.
DIAL
[ ] to select SET.
one or more times until "T" and "rT" appear.
]
] to select the subaudible tone frequency.
] to set the tone frequency and exit Set
to activate memory channel programming mode.
] for 1 sec. to program the channel. Three
] to activate Memory mode, then rotate
to activate Set mode.
several times until BAK is displayed.
] to exit Set mode.
DIAL
[ ] to
Page 6 of 6