Icom ID-800H Operating Manual page 4

Operating in Memory Mode
● If necessary, press
[
● To change the Memory channel, rotate
● To start a scan, press and hold
● To stop a scan, press
Alternatively: See "Using the HM-133 Microphone" section for instructions
on using the microphone ▲/▼ and/or keypad buttons to perform these
operations.
Memory Bank Selection
The ID-800H has 10 Memory Banks (A to J), each of which can contain up
to 500 Memory channels. To select a Memory channel within a Bank:
1. If necessary, press
BAND●MODE
2. Press [
selection. (The Bank initial blinks on the LCD display.)
DIAL
3. Rotate [ ] to display the desired Memory Bank.
BAND●MODE
4. Press [
stops blinking.)
5. Rotate the Dial to select a Memory channel within the bank.
To return to regular Memory mode, Press
Using the Monitor Function
This function is used to listen to weak signals
without disturbing the squelch setting.
● To activate, press MONI●DTMF
[
squelch. (The "Busy" icon blinks on the LCD
display`.)
● To cancel, press MONI●DTMF
[
Selecting the Call Channel
Call channel is a pre-programmed Memory channel
accessed by pressing the Call channel button.
M/CALL●PRIO
1. Press [
activate Call Channel mode.
BAND●MODE
2. Press [
channel. (In Memory mode, the "C1" or "C2"
icon blinks. In VFO mode, the "c" icon blinks.)
3. To cancel Call Channel mode:
● To return to Memory mode, press
M/CALL●PRIO
[ ]
● To return to VFO mode, press
V/MHz●SCAN
[ ].
Icom ID–800H Mini–Operating Guide by W5JCK, September 2007
M/CALL●PRIO
] to activate Memory mode.
DIAL
[
V/MHz●SCAN
[
V/MHz●SCAN
[ ].
M/CALL●PRIO
[ ] to activate Memory mode.
] one or more times to activate the Memory Bank
] to select the Memory Bank. (The Bank initial
BAND●MODE
[
] to open the
] again.
] one or more times to
] to select the desired call
one or more times.
].
] for 1 second.
] twice.
Alternatively: Press the HM-133 microphone
BANK●MONI●1
button [
Monitor function.
Alternatively: Press and hold the HM-133
microphone button
activate the Call Channel mode, then press
BAND●MODE
[ ] to select the desired call channel in
the main Band.To cancel, press
return to Memory mode, or press
return to VFO mode.
] to activate or cancel the
MR●CALL
[ ] for 1 sec. to
MR●CALL
[
VFO/LOCK
[
Page 4 of 6
] to
] to