Programming A Memory Channel - Icom IC-2720H Operating Manual

6. Set the Repeater Tone Encoder Type and Tone Frequency:
SET●LOCK
a. Press [
SET●LOCK
b. Press [
DIAL
c. Rotate [
Example: Set tone frequency to 110.9 for the 146.940 repeater.
TONE●DTMF
d. Press [
You can now operate through the repeater. To ensure you do not lose these settings, you can
save this information to a Memory channel.

Programming a Memory Channel

VFO settings, including the set mode contents such as subaudible tone frequency or offset, can
be programmed into a memory channel.
1. Press and hold L/R
channel programming mode. Three beeps sound and the
icon appears on the LCD display.
DIAL
2. Rotate [ ] to select a blank Memory channel in which to program
the current settings. Be certain you select a blank channel so as to not
overwrite any existing channels.
M/CALL●MW
3. Press and hold [
beeps will sound indicating the channel was programmed.
Assigning a Memory Channel to a Memory Bank
Each memory channel and the call channel can be programmed with an alphanumeric
name for easy recognition. Names can be a maximum of six characters.
M/CALL●MW
1. Press L/R [
DIAL
then rotate [ ]
MAIN●BAND
2. Press and hold [
MAIN●BAND
3. Press [
M/CALL●MW
4. Press and hold [
desired Memory bank. The bank initial starts blinking.
M/CALL●MW
5. Press [
bank initial stops blinking.
Icom IC–2720H Mini–Operating Guide by W5JCK, September 2007
] to activate Set mode.
one or more times until "T" and "rT" appear.
]
] to select the subaudible tone frequency.
] to set the tone frequency and exit Set mode.
M/CALL●MW
[ ] for 1 sec. to activate memory
] for 1 sec. to program the channel. Three
] one or more times to activate Memory mode,
to select the Memory channel.
for 1 sec. The "– –" icon starts blinking.
]
again. The "– –" icon stops blinking.
]
] for 1 sec., then rotate
] again to program the channel into the bank. The
indicator
DIAL
[ ] to select the
Page 6 of 6