Heater Expansion; Gas Connection; Venting; Start Up 'Smoke - Schwank STS-JZ Installation & Owner's Manual

WARNING
WARNING
heater to the gas supply. The gas supply must be connected tested in accordance with all lo-
cal, state, provincial, and national codes (ANSI Z223.1/NFPA 54 in USA; B149.1 in Canada)
and as indicated in this manual.
WARNING
all local, state, provincial, and national codes (ANSI Z223.1/NFPA 54 in USA;
B149.1 in Canada) and as indicated in this manual.
WARNING
During start up, the heating of material coatings used in the production process of tubes and
reflectors will create smoke during the initial period of operation. This condition is normal and
temporary .
Ensure that there is sufficient ventilation to adequately clear any smoke from the space.
Notify site and safety personnel to ensure that alarm systems are not unduly activated.

Heater Expansion

It is a normal condition that during heat-up and cool-down a tube
heater will expand and contract. Allowances for heater expansion
must be made in the gas connection, venting and combustion air
ducting. Improper installation, alteration, or adjustment can result in

Gas Connection

Improper installation, connection, or adjustment can result in property
damage, toxic gases, asphyxiation, injury or death. Use the approved
Type 1 hose gas connector supplied with the heater to connect the
Refer to Section 13

Venting

Inadequate venting of a heater may result in asphyxiation, carbon
monoxide poisoning, injury or death. This heater may be directly or
indirectly vented from the space. Venting must be in accordance with
Start-Up 'SMOKE' Condition
Refer to Sections 11 & 12
5
STS-JZ / IQ I&O Manual
IM101220
RD: MAY 2012
RL: 14D - BA