7 7
Appliance Preparation
CAUTION
Sharp Edges
•
Wear protective gloves
and safety glasses during
installation.
A. Convert from Top Vent to Rear Vent
•
Remove the screw holding heat shield cover plate to top
of appliance and set aside. See Figure 7.1
Note: If the appliance is to be top vented discard this plate
and replace the screw you removed. If the appliance is to
be rear vented, continue to the next step and Figure 7.2.
Figure 7.1
Cover Plate, Top of Appliance
•
Remove the white insulation and set aside. See
Figure 7.2.
Figure 7.2
Remove White Insulation
Heatilator • Caliber CNXT Series • 4047-132 Rev P • 11/07
•
Remove three remaining screws holding the plate
surrounding fl ue. See Figure 7.3. Remove plate and set
aside.
Figure 7.3
Cover Plate, Remove Screws
•
Remove four screws holding inner plate surrounding the
fl ue. See Figure 7.4. Remove inner plate and discard.
Figure 7.4
Inner Plate, Top of Appliance
29