Important Safety; Mounting The Frame - Da-Lite Multi-Mask Imager Instruction Book

Important Safety

When using your video equipment, basic safety precautions should always be followed, including the following:
1. Read and understand all instructions before using.
2. Position the cord so that it will not be tripped over, pulled,
or contact hot surfaces.
3. If an extension cord is necessary, a cord with a current rating
at least equal to that of the appliance should be used. Cords
rated for less amperage than the appliance may overheat.

Mounting The Frame

Professional mounting techniques should be adhered to. Da-Lite Screen Company cannot be liable for substandard
or faulty installations.
Frame Assembly
Assembly of the screen should be in a clean environment.
1. Connect the four frame pieces by matching the colored
tapes on the ends of the frame pieces. See Figure 1.
2. Secure with the supplied 5/16" setscrews.
Positioning the Frame on the Wall
1. Without the screen fabric attached,
position the frame
on the wall at the location you desired.
2. Make sure the unit is level and plumb.
(You may need
to use shims between the brackets and
the wall to achieve vertical plumb.)
3. Mark the position of the bracket holes on
the wall.
See Figure 2.
CAUTION: If the screen is not mounted
so that it is level and plumb, horizontal
masking may jam on retraction.
2
Figure 1
Figure 2
4. To reduce the risk of electric shock, do not disassemble this
appliance. Contact an authorized service dealer when repair
work is required. Incorrect reassembly can cause electric
shock when the appliance is used subsequently.
5. The use of an accessory attachment not recommended
by the manufacturer may cause a risk of fire, electric shock,
or injury to persons.
Unpacking and Unrolling the Screen
The viewing side of the screen surface is rolled to the inside.
The screen surface is rolled lengthwise.
1. Remove screen from packaging.
2. On a clean floor, unroll the screen surface viewing side up.
3. Allow the paper to unroll between backside of the screen
surface and floor. See Figure 3.
CAUTION:
• Be careful not to touch or scratch the viewing side
of the surface with fingernails and any sharp tools.
• Do not use any tools to fasten the screen surface
to the frame.
• Do not fold or crease the screen.
Figure 3