Installing The Switch Housing - Hunter 42008-01 Installating And Operation Manual

7 • Installing the Switch Housing
Gasket
10
Step 7-4
Hunter Fan Company
Note: If you are installing a light fi xture, do NOT install the
switch housing without fi rst referring to the instructions
included with the light fi xture.
7-1. Align the holes on the blade iron cover and gasket and stick two
screws through two of the holes.
7-2.  read the plug connector from the mounting plate through
the gasket and cover. Partially install the gasket and cover to the
mounting plate with the two screws.
Blade
Iron Cover
7-3. Place the upper switch housing over the two screws and turn
Steps 7-1 – 7-2
counterclockwise so that the screws fi t securely in the slots.
7-4. Partially install the third screw and then tighten all three screws
securely.
7-5. Connect the upper plug connector from the motor to the lower
plug connector in the switch housing assembly.
Note: Both plug connectors are polarized and will only fi t together
one way. Make sure the connectors are properly aligned before
connecting them. Incorrect connection could cause improper
operation and damage to the product.
7-6. To attach the lower switch housing, thread the thumb screws
through the side holes of the upper switch housing and tighten
Step 7-3
them securely.
Note: You can customize
your Hunter fan with a
number of accessory light
kits.
 umbscrew
Steps 7-5 – 7-6
42008-01 • 12/07/05