M7G-Pcb - Oki OKIPAGE 14e Service Manual

3.3.21 M7G-PCB

(1) Remove the upper cover assy (see 3.3.1).
(2) Remove the operator panel assy (see 3.3.4).
(3) Remove the face up stacker assy (see 3.3.8).
(4) Remove the lower base unit (see 3.3.5).
(5) Remove the connector (2NDTRAY) 6.
(6) Remove three screws 1.
(7) Move the M7G-PCB 2 in the direction of arrow to disconnect it from the power supply/sensor
board 3.
(8) Remove the connector FAN, and disconnect the fan motor 4.
(9) Remove the M7G-PCB 2, together with the PCB guide plate (remove the fan motor 4 at the
same time).
(10) Remove four screws 8 and remove the PCB guide plate 7 from the M7G-PCB 2.
Note : When reinstalling the M7G-PCB 2 onto the guide plate 7, be careful not to bend the base
plate (it is desirable to place a block underneath it to prevent bending).
41605601TH Rev.2
8
4
1
1
7
6
8
8
2
3
66 /