Items On Hardware; Items On Firmware - hilscher CIFX 50-XX User Manual

Device Connections and Switches
9.8.3

Items on Hardware

Item Explanation
SYNC Signal 3,3 V (LVTTL), maximum load 6 mA
Connector SYNC connector, X51 (for the PC cards cifX, as indicated under section Pin Assignment SYNC
Connector, X51 (CIFX 50 50E 70E) on page 105.)
Female connector, 3 pin, pitch spacing 1.25 mm (for example, the type Molex series 51021)
and female crimp contacts in design (e. g. type Molex series 50079/50058)
SYNC connector, J1 (for CIFX 100EH-RE\CUBE)
Male Connector with jumper, 3 pin, pitch spacing 2,54 mm
Max. Cable Recommendation: Max. 50 mm
Length
Note: Take EMC into consideration for the cable laying
9.8.4

Items on Firmware

Protocol
EtherCAT Slave
sercos Master
sercos Slave
PC Cards cifX PCI, PCIe, Low Profile PCIe | Installation, Operation and Hardware Description
DOC120204UM39EN | Revision 39 | English | 2014-01 | Released | Public
Table 75: SYNC Connector: SYNC Signal, Connector, Max. Cable Length
The firmware determines the input signal or output signal. The following
table shows the meaning of the SYNC signals for each protocol.
Signal IO_SYNC0
Input/Output
SYNC 0
Output
External trigger to start bus
cycle
Input
Rising edge
CON_CLK
Output
Table 76: Meaning of the SYNC Signals for each Protocol
Signal IO_SYNC1
Input/Output
SYNC 1
Output
-
DIV_CLK
Output
106/184
From Remarks
Firmware
Version
- Configurable
2.0.8.0 -
3.0.10.0 Configurable
© Hilscher, 2008-2013