Cifx 70E-Re, Cifx 70E-Re\Mr - hilscher CIFX 50-XX User Manual

Technical Data

10.1.19 CIFX 70E-RE, CIFX 70E-RE\MR

CIFX 70E-RE,
CIFX 70E-RE\MR
Part
Communication
Controller
Integrated Memory
System Interface
Ethernet
Communication
Ethernet Interface
PC Cards cifX PCI, PCIe, Low Profile PCIe | Installation, Operation and Hardware Description
DOC120204UM39EN | Revision 39 | English | 2014-01 | Released | Public
Parameter
Name
Part No.
Description
Function
Type
RAM
FLASH
Size of the Dual-Port Memory
MRAM (only CIFX 70E-RE\MR)
Bus Type
Transmission Rate
Data Access
Width for the data access to the
Dual-Port Memory (DPM)
Supported Real-Time Ethernet
communication systems
(determined by the loaded
firmware)
Ethernet Frame Types
Transmission rate
Interface Type
Galvanic Isolation
Isolation Voltage
Half duplex/Full duplex
Auto-Negotiation
Auto-Crossover
Connector
Channel 0 and 1
Value
CIFX 70E-RE
1.259.100
PC Card cifX Low Profile PCI Express Real-Time-Ethernet
Master or Slave (Low Profile PCIe with RTE)
Communication interface with PCI Express and
Ethernet interface
netX 100 processor
8 MB SDRAM
4 MB serial Flash EPROM
64 KByte
128Kbyte (= 64K Words);
Note: Using the cifX Device Driver (from Version 1.1.1.0)
access to this memory is possible and it can be used as a
remanent memory.
PCI Express, One Lane Port, according to [bus spec 2,
Rev. 2.0] and [bus spec 3], refer to section Overview,
page 107.
2 GBit/s
DPM or DMA (Direct Memory Access)
32-Bit
EtherCAT Master, EtherCAT Slave
EtherNet/IP Scanner (Master),
EtherNet/IP Adapter (Slave),
Open Modbus/TCP
POWERLINK Controlled Node/Slave
PROFINET IO-Controller (Master),
PROFINET IO-Device (Slave)
sercos Master, sercos Slave
VARAN Client (Slave)
Ethernet II
100 MBit/s,
10 MBit/s (depending on loaded firmware)
100 BASE-TX,
10 BASE-T (depending on loaded firmware),
refer to section Ethernet Interface, page 98.
isolated
1000 VDC (tested for 1 minute)
depending on loaded firmware,
supported (at 100 MBit/s)
depending on loaded firmware
depending on loaded firmware
2* RJ45 Socket
With loaded EtherCAT Master firmware only the RJ45
channel 0 can be used, channel 1 is deactivated.
Beginning with the EtherCAT Master firmware version 3
channel 1 can be reactivated if redundancy is activated.
For Open Modbus/TCP with V2.3.4.0 and higher both
RJ45 channels can be used.
138/184
CIFX 70E-RE\MR
1.259.103
© Hilscher, 2008-2013