Checking The Steering Damper - Yamaha YZFR1W 2007 Service Manual

4. Install:
• Throttle grip
• Throttle cable housing "1"
• Throttle cables
NOTE:
Align the projection "a" on the throttle cable
housing with the hole "b" in the right handlebar.
5. Install:
• Clutch lever holder "1"
NOTE:
Align the slit on the clutch lever holder with the
punch mark "a" on the left handlebar.
6. Install:
• Left handlebar switch "1"
NOTE:
Align the projection "a" on the left handlebar
switch with the hole "b" on the left handlebar.
7. Install:
• Handlebar grip
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Apply a thin coat of rubber adhesive onto
the end of the left handlebar.
b. Slide the handlebar grip over the end of the
left handlebar.
c. Wipe off any excess rubber adhesive with a
clean rag.
EWA13700
WARNING
Do not touch the handlebar grip until the
rubber adhesive has fully dried.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
8. Adjust:
• Clutch cable free play
Refer to "ADJUSTING THE CLUTCH
CABLE FREE PLAY" on page 3-14.
Clutch lever free play
10.0–15.0 mm (0.39–0.59 in)
9. Adjust:
• Throttle cable free play
Refer to "ADJUSTING THE THROTTLE
CABLE FREE PLAY" on page 3-8.
Throttle cable free play
3.0–5.0 mm (0.12–0.20 in)
EAS4C81004

CHECKING THE STEERING DAMPER

1. Check:
• Steering damper body
Damage/oil leaks → Replace.
(It replace with the assembly.)
• Steering damper rod
Bends/scratch → Replace.
(It replace with the assembly.)
• Bearing
Damage/pitting → Replace.
(It replace with the assembly.)
4-48
HANDLEBARS