7. Check:
• Gear teeth
Damage/wear → Replace the starter
motor.
EAS24800
ASSEMBLING THE STARTER MOTOR
1. Install:
• Brush holder
• Armature
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Pull both the brush spring and the brush
outside and hook the brush spring to the
groove portion at the side of the brush.
b. Insert the armature into the brush holder
and push the brush inside until it touches
the armature.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
2. Install:
• O-rings
New
• Rear cover "1"
NOTE:
Align the tab "a" on the brush holder "2" with
the tab "b" in the starter motor rear cover.
ELECTRIC STARTER
3. Install:
• Nut "1"
Nut
5 Nm (0.5 m·kg, 3.6 ft·lb)
4. Install:
• Starter motor yoke "1"
• Gasket "2"
New
• Starter motor rear cover "3"
• Starter motor assembling bolts "4"
Starter motor assembling bolt
5 Nm (0.5 m·kg, 3.6 ft·lb)
NOTE:
Align the match marks "a" on the starter motor
yoke with the match marks "b" on the front and
starter motor rear covers.
5-42