EAS14B1092
CHECKING THE STEERING DAMPER
Refer to "CHECKING THE STEERING
DAMPER" on page 4-74.
EAS14B1093
CHECKING THE CHASSIS FASTENERS
Make sure that all nuts, bolts, and screws are
properly tightened.
Refer to "CHASSIS TIGHTENING TORQUES"
on page 2-20.
EAS21700
LUBRICATING THE BRAKE LEVER
Lubricate the pivoting point and metal-to-metal
moving parts of the levers.
Recommended lubricant
Silicone grease
EAS14B1100
LUBRICATING THE CLUTCH LEVER
Lubricate the pivoting point and metal-to-metal
moving parts of the levers.
Recommended lubricant
Lithium-soap-based grease
EAS21710
LUBRICATING THE PEDAL
Lubricate the pivoting point and metal-to-metal
moving parts of the pedal.
Recommended lubricant
Lithium-soap-based grease
EAS21380
ADJUSTING THE SHIFT PEDAL
TIP
The shift pedal position is determined by the
installed shift rod length "a".
1. Measure:
• Installed shift rod length "a"
Incorrect → Adjust.
Installed shift rod length
262.5–265.5 mm (10.33–10.45
in)
PERIODIC MAINTENANCE
2. Adjust:
• Installed shift rod length
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Loosen both locknuts "1".
b. Turn the shift rod "2" in direction "a" or "b" to
obtain the correct shift pedal position.
Direction "a"
Installed shift rod length increases.
Direction "b"
Installed shift rod length decreases.
c. Tighten both locknuts.
d. Make sure the installed shift rod length is
within specification.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EAS14B1094
CHECKING THE SIDESTAND
1. Stand the vehicle on a level surface.
EWA13120
WARNING
Securely support the vehicle so that there
is no danger of it falling over.
TIP
Place the vehicle on a suitable stand so that
the sidestand is elevated.
2. Check:
Unsmooth operation → Replace the defec-
tive part(s).
3-22