Connection - Hitachi Kokusai Electric KP-M1A Operation Manual

11. Connection

Connection of options
KP-M1A
When operating the
camera in external
sync drive mode,
connect the sync
signals(HD/VD).
Basic connection
KP-M1A
Trigger B IN
When operating the
camera in external
sync drive mode,
connect the sync
signals.
When Connecting more than one monitor, set the 75-ohm termination switch of the last unit only to ON.
When operating the camera in external sync drive mode, input the sync signal(HD/VD).
Available voltage rangeis 11 to 13V.
Before turning on an external power supply unit, be sure to check the polarities of the power supply.
KP-M1A
Coaxial cable
Connect either of the cables.
Camera cable JUNCTION BOX
(Option) JU-M1A
EXT HD IN
EXT VD IN
or
Trigger A IN
Coaxial cable
EXT HD IN
EXT VD IN
or
Trigger A IN
Coaxial cable
+12V
GND
Trigger B IN
Connect either of the cables.
Coaxial cable
+12V
Regulated
power
supply
GND
Set to 12V DC.
Image processor
or
Video monitor
AC adaptor
AC
AP-130
When not using the
AP-130, supply 12V
from the rear of the
Junction box.
Image processor
or
Video monitor
AC
- 25 -