SOYO SY-6IBM User Manual page 29

Hardware Setup
Step 12. CMOS Clearing (JP5)
After you have turned off your computer, clear the CMOS memory
by momentarily shorting pins 2-3 on jumper JP5, for a few seconds.
Then restore JP5 to the initial 1-2 jumper setting in order to recover
and retain the default settings.
Jumper JP5 can be easily identified by its white colored cap.
CMOS
Clearing
Short pin 1-2 to
JP5
retain the new
Setting
CMOS settings.
Note: You must unplug the ATX power cable from the ATX power
connector when performing the CMOS Clear operation.
Step 13. Power Button Enable (JP8)
Your system can be power on by either pressing a power button or
typing in a password, which can be set in the BIOS SOYO COMBO
Setup. To avoid being unable to power up the system due to of
forgetting the password, you can place a jumper cap to short JP8.
This will always enable the Power Button.
Power Button
Enable
JP8 Setting
Retain CMOS Data
Power Button always
enabled
Short pin to
always enable
the Power
Button.
Clear CMOS Data
3 Short pin 2-3 for
2
at least 5 seconds
1
to clear the CMOS.
according to BIOS
Open pin for a
Power Button
function
according to the
BIOS setting.
26
SY-6IBM
Power Button
setting
3
2
1