Using The Oven Control; Setting Electronic Clock; Flashing Display - Amana Gas Freestanding BIG OVEN Service Manual

Using the Oven Control

Flashing Display

When power is connected
or interrupted, oven display flashes.
Press CLOCK to reset display.
Clock may need to be reset.
Making the Numbers
Increase at a Faster Rate
Time increases in larger increments
the longer the or pad is held.
+
Timer Signal
When time elapses, beep will sound.
Press TIMER ON/OFF pad to stop timer
and return to clock display.
Preheat Signal
After setting oven to bake and selecting
a temperature, oven preheats. When
oven reaches set temperature, signal
sounds. The preheat light will shut off
and remain off after oven has reached
the selected temperature.

Setting Electronic Clock

The 12 hour clock does not display
is connected or restored, display flashes until
RECALL OVEN TEMP/CLOCK pad is pressed or
temperature knob is turned.
1. Press RECALL OVEN TEMP/CLOCK pad.
2. Press or pads until correct time-of-day
+
displays.
3. Time is set after 5 seconds of no adjustment.
Setting Minute Timer
The timer is a timer only. Electronic timer does not control bake, broil or
self-clean function. Timer can be set up to 11 hours and 59 minutes.
1. Press TIMER ON/OFF pad.
2. Press or pad until desired amount of time
+
displays.
• Time increases in 1 minute and 10 minute
increments.
• Timer begins counting down automatically
after time is entered.
• To view clock while timer counts down,
press RECALL OVEN TEMP/CLOCK pad. Timer will return after
3 seconds of no input.
3. Press and hold TIMER ON/OFF pad to cancel timer signal.
• After time elapses, timer beeps a single, three second tone.
Resetting and Canceling Timer
To reset the time when remaining time is displayed, press
TIMER ON/OFF pad, then
To cancel timer when remaining time is displayed or when signal is
beeping, press and hold TIMER ON/OFF pad.
C–15
, or military time. When power
AM PM
or pad until new time displays.
+
RS2310005 Rev. 0