Before Your First Fire; Hopper Lid Latch And Hopper Switch - Heatilator ECO-NZ-PS35 Owner's Manual

2. Heat Output Controls
This appliance is equipped with a heat output control
switch that has three settings or burn rates; low, medium
and high. "Figure 2"
The fire will start up and run on high for 15 minutes to
warm the flue and then run as the burn rate for which it is
set. If the appliance is set at one of the lower settings, it
will run quieter but take longer to heat up an area than if it
were set at a higher burn rate.
Fire Hazard.
Keep combustible materials, gasoline and
other flammable vapors and liquids clear of
appliance.
Do NOT store flammable materials in the appliance's
vicinity.
• DO NOT USE GASOLINE, LANTERN FUEL,
KEROSENE, CHARCOAL LIGHTER FLUID OR SIMILAR
LIQUIDS TO START OR "FRESHEN UP" A FIRE IN THIS
HEATER.
• DO NOT BURN GARBAGE OR FLAMMABLE FLUIDS
SUCH AS GASOLINE, NAPHTHA OR ENGINE OIL.
• DO NOT USE CHEMICALS OR FLUIDS TO START THE
FIRE.
• Keep all such liquids well away from the heater while it is
in use.
• Combustible materials may ignite.
F. Before Your First Fire
1. First, make sure your appliance has been properly
installed and that all safety requirements have
been met. Pay particular attention to the fire
protection and flueing.
www.heatilatorecochoice.com
Figure 2
WARNING
Heatilator • ECO-NZ-PS35 • 7072-111B • December 1, 2011
2. Double check that the ash drawer and firebox are
empty!
3. Close and latch the door.
NOTE: The tip of the thermocouple must be in contact
with the inside end of the thermocouple cover or
missed ignitions can occur.
G. Hopper Lid Latch and Hopper Switch
1. Lift up the hopper lid and lock into open position.
Now you can fill the hopper with fuel.
2. The hopper switch is designed to shut down the
feed motor when the hopper lid is open. "Figure 3"
3. To close the hopper lid, while holding lid open with
one hand, push the bottom of the latch inwards to
release from locked position and then slowly close
the hopper lid. "Figure 4"
Hopper Lid Latch
Figure 3
Figure 4
Hopper Switch
Push Bottom of Latch
Inward to Release
9