Specifications; Glass Specifications; Kw & Efficiency Specifications; Specification Table - Heatilator ECO-NZ-PS35 Owner's Manual

1

Specifications

A. Glass Specifications
This appliance is equipped with 5mm ceramic glass.
Replace glass only with 5mm ceramic glass. Please
contact your dealer for replacement glass.
B. kW & Efficiency Specifications
kW input will vary, depending on the brand of fuel you use
in your stove. Consult your dealer for best results.
NOTE: Hearth & Home Technologies, manufacturer of
this appliance, reserves the right to alter its products, their
specifications and/or price without notice.
C. Specification Table
Classification
Class 1 IP-20
Voltage 220-240 volts
Max Power Requirement
450 Watts
High
Mean flue gas temp
189°C
Fuel consumption
1.9kg/hour
Heating power output - 7kW
Average particulate emissions
(dry weight)
0.4g/kg
Gross Calorific value of pellets
(dry weight)
20.1MJ/kg
6
Testing Standard
Efficiency AS/NZS 5078:2007
Appliance AS/NZS 4886:2007
Current 0.7-2.0 Amps
Weight 120kg with full hopper
Mean flue gas temp
Fuel consumption
Heating power output - 5.2kW
Average emission rate
Wood pellets -6mm Ø - complying with draft
standard AS/NZS4014.6:2008
Heatilator is a registered trademark of Hearth & Home Technologies.
Heatilator • ECO-NZ-PS35 • 7072-111B • December 1, 2011
WARNING! Risk of Fire! Hearth & Home Technologies
disclaims any responsibility for, and the warranty and
agency listing will be voided by the below actions.
DO NOT:
• Install or operate damaged appliance
• Modify appliance
• Install other than as instructed by Hearth & Home
Technologies
• Operate the appliance without fully assembling all
components
• Over fire
• Install any component not approved by Hearth &
Home Technologies
• Install parts or components not Listed or approved
• Disable safety switches
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
For assistance or additional information, consult a qualified
installer, service agency or your dealer.
Medium
166°C
1.4kg/hour
25mg/MJ
Fuel type
Description
Residential Wood Pellet Heater
Frequency 50Hz
Hopper capacity 20kg
Low
Mean flue gas temp
110°C
Fuel consumption
0.7kg/hour
Heating power output - 2.7kW
Average efficiency
71%
www.heatilatorecochoice.com