Igniter Replacement; Baffle Removal & Replace - Heatilator ECO-NZ-PS35 Owner's Manual

5. T he locating bracket is attached to the feed tube
with an 8 X 32 wing nut. Remove the wing nut to
detach the bracket from the feed tube.
6. Disconnect the two wires from the snap disc.
7. U sing a #2 Phillips screwdriver, remove the screw
securing the snap disc to the bracket. "Figure
22".
8. R e-install in reverse.
Snap Disc Bracket
Figure 22
D. Igniter Replacement
WARNING
Shock Risk.
• Igniter Wires MUST route through wire
retainer hook.
• Failure to do so may result in:
• Pre-mature failure of igniter
• Shorted out igniter
• Appliance failing to light
• Damaged control box
1. Shut down the appliance or turn down the
thermostat and let the appliance completely cool
down. After the appliance has cooled down,
unplug it and remove the ash drawer.
2. The wire leads to the igniter are connected to the
wire harness with 1/4 inch male / female spade
connectors.
3. Follow the directions on page 18 to remove the
upper and lower right side panels to expose the
spade connect
4. Disconnect the spade connectors and remove the
igniter from the chamber. Loosen thumb screw
and slide igniter out.
20
Remove Screw
Heatilator • ECO-NZ-PS35 • 7072-111B • December 1, 2011
5. Install new igniter into the chamber and tighten
thumb screw. The wires MUST route through the
wire retainer hook and then re-connect the wires
to the 2 leads with the spade connectors. "Figure
23".
Firepot
Igniter
Chamber
Igniter
Thumb Screw
Figure 23
6. Double check that the igniter wires are clear of any
movement, i.e. ash drawer, firepot cleaning rod, ,
etc.
7. Re-install the ash drawer and side panel and re-
connect the power.
E. Baffle Removal & Replace
1. Shut down the appliance or turn down the
thermostat and let the appliance completely cool
down.
2. Remove the centre baffle first by using the handle
at the top of the baffle and pull up and then
towards you. The hooks on the baffle will slide out
of the slots in the bracket. "Figure 24"
Figure 24
Thermocouple &
Thermocouple Cover
Firepot Cleaning
Rod
Igniter Wires
MUST BE ROUTED
Through Wire Retainer Hook
Use handle at top of
center baffle to pull up
and then towards you.
www.heatilatorecochoice.com