Heatilator ECO-NZ-PS35 Owner's Manual page 28

Parts Included in 3 inch Kit OAK-3: 2 wire ties, 1
collar assembly, 1 termination cap assembly, 1 trim ring,
fasteners.
Tools Needed: Phillips Head screw driver; wire cutters;
hole saw or jig saw, and the length of flex hose needed for
your installation if using the 3 inch kit.
10. M easure distance from floor to air vent opening in
appliance and mark location on wall.
11. Use saw to cut opening in wall.
• 2 inch kit: Cut a 2-1/2 to 3 inch opening on inside
wall and a 3 to 3-1/2 inch opening on outside of
house.
• 3 inch kit: Cut a 3-1/2 to 4 inch opening on inside
wall and a 4 to 4-1/2 inch opening on outside of
house.
12. U se wire tie or hose clamp depending on the
Outside Air Kit to secure flex pipe to collar
assembly.
13. S lide trim ring over flex pipe and run pipe through
wall.
14. A ttach flex pipe to outside termination cap with
second wire tie or hose clamp.
15. S ecure termination cap to outside surface.
16. S ecure trim ring to interior wall.
WARNING
Fire Risk.
Follow Flue Manufacturer's Instructions for
Proper Installation
Maintain minimum clearances to combustibles
28
Heatilator • ECO-NZ-PS35 • 7072-111B • December 1, 2011
www.heatilatorecochoice.com