Bella Linx Slow Cookers Assembly Instructions - Bella 14063 Instruction Manual

4. Plug the detachable power-supply cord's connectors into the receptacle
on the right side of the LINX base unit 1.
5. Plug cord into a 120V AC electrical outlet.
6. Turn all control dials to HIGH and allow to heat for approximately 20
minutes. You will notice a slight odor; this is normal and should quickly
disappear.
7. Turn all control dials to OFF and allow to cool for 20 minutes.
8. Wearing oven mitts, grasp each of the stoneware pot handles carefully
to lift and remove stoneware pots from each aluminum liner; pour out
the water from the stoneware pots.
9. Rinse all stoneware pots, dry thoroughly, and replace in each LINX base
unit's aluminum liner.

BELLA LINX Slow Cookers Assembly Instructions

NOTE: These instructions apply to all configurations: 2 or 3 ... up to 6 units.
All LINX slow cookers are identical
1. Link units (2 or 3...up to 6) together. Determine the number of BELLA
LINX slow cookers needed (2 to 6).
2. Lift LINX base unit 2 to slide the tab (located on the left side) down into
the groove on the right side of LINX base unit 1. If 3 units are connected,
lift LINX base unit 3 to slide the tab (located on the left side) down into
the groove on the right side of LINX base unit 2. (See Figure 2.)
Base Unit 1
WARNING: When using more than 1 LINX base unit, always make sure base
units are properly assembled with the tab along the side of the unit linked
securely into the groove of the next unit.
CAUTION: NEVER CARRY MULTIPLE INTERCONNECTED LINX BASE UNITS.
IMPORTANT: Always disconnect all LINX base units before moving to serve
or to clean. Follow detailed instructions outlined in the section entitled:
"Care & Cleaning Instructions." (See Figure 5.)
SO-310634 LINX IM_r2.indd 9
Tab
Groove
Base Unit 2 Base Unit 1 Base Unit 2
9
Figure 2
Tab
Groove
Base Unit 3
2013-05-24 9:06 AM