Revision History - Basler A101f User Manual

Revision History

Doc. ID Number Date
DA039101 6-Feb.-2001
DA039102 18-Apr.-2001
DA039103 25-July-2001
DA039104 20-May-2002
f
BASLER A101
DRAFT
Changes
Initial release.
Made numerous small changes to grammar and phrasing.
Added connector information in Section 2.1.3.
Added ripple specification to Table 1-1 and Section 2.3.
Added Section 3.10 containing information on the low smear feature.
This feature is available on cameras with FPGA firmware version 2.17 or
higher. Version 2.17 firmware will be included in cameras manufactured
after May 1, 2001.
Added Section 4.6 containing information about how to access firmware
version numbers.
Updated the camera model information in Section 1.1.
Moved the information about color creation in the A101
section (Section 3.11) and added information about YUV output, white
balance, and using a color camera in monochrome modes. The YUV out-
put and white balance features are available on color cameras with an ID
number of 1XXX13053 or higher.
Updated the note box on page 3-13 to indicate that binning is only avail-
able on monochrome cameras.
Corrected the content of the note box at the top of page 3-15.
Updated the list of available output formats and modes in Section 3.12.
Updated the note for register 80CH on page 4-6.
Removed the chapter on camera installation from this manual. The in-
stallation information now appears only in the A101
Corrected the device information in Section 2.2.3 and Figure 2-3.
Updated the exposure control information in Section 3.2.3 to specify the
use of rising edge triggering.
Deleted the detailed timing explanations from Sections 3.2.2 and 3.2.3.
Added Section 3.2.4 containing information about recommended meth-
ods for exposure start control.
Updated Figure 3-12 in Section 3.8 and added information about mini-
mum AOI size to the note box.
Corrected the descriptions of test image one and test image two in Sec-
tion 3.9.
Corrected Figure 3-17 in Section 3.11.
Added information about the BCAM driver to page 4-1.
Updated the information about the advanced features registers in Sec-
tion 4.5.
Revision History
to a separate
fc
Installation Guide.
f
i