Reset To Factory Default Settings; Upgrading System Firmware - Thecus N0204 miniNAS User Manual

Module Management
Item
Name
Version
Description
Enable
Status
Uninstall
Enable (button)
Disable
Browse
Install

Reset to Factory Default Settings

From the System menu, choose the Factory
Default item and the Reset to Factory
Default screen appears. Press Apply to reset
the N0204 miniNAS to factory default settings.
Press Cancel to go back to the main menu.
WARNING
Resetting to factory defaults will not erase
the data stored in the hard disks, but WILL
revert all the settings to the factory default
values.

Upgrading System Firmware

From the System menu, choose the Firmware
Upgrade item and the Firmware Upgrade
screen appears.
Follow the steps below to upgrade your
firmware:
1. Use the Browse button to find the
firmware file, and then press Apply.
2. Press OK to upgrade the Firmware.
3. During the firmware upgrade was in
process, the system will appear the rate
of progress.
4. Once the upgrade is complete, the
system will pop a message; press OK to reboot the system.
Description
Displays the name of the module.
Displays the module version.
The description of the module.
Displays whether the module has been enabled or not.
Displays the status of the module.
Click to uninstall the module.
Click to enable a module.
Click to disable a module.
Click to browse the folder of your PC to locate the module files.
Click to install the listed module into your N0204 miniNAS
37