Usb Copy; Typical Setup Procedure; Step 1: Network Setup; Step 2: Raid Creation - Thecus N0204 miniNAS User Manual

USB Copy

The USB Copy function enables you to copy files stored on USB devices such as USB disks
and digital cameras to the N0204 miniNAS by press USB copy button. To use USB copy,
follow the steps below:
1. Plug your USB device into USB2.0 port on the Front Panel.
2. Press USB copy Button and the N0204 miniNAS will start copying USB disks connected
to the front end USB2.0 port.
3. The USB LED show
Blinking Green: Copy activity.
Solid Green: Copy Success.
Solid Red: Copy Fail.

Typical Setup Procedure

From the Web Administration Interface, you can begin to setup your N0204 miniNAS to use
on your network. Setting up the N0204 miniNAS typically follows the five steps outlined
below.
For more on how to use the Web Administration Interface, see Chapter 4: System
Management > Web Administration

Step 1: Network Setup

From the Web Administration Interface, you can configure the network settings of the N0204
miniNAS for your network. You can access the Network menu from the menu bar.
For details on how to configure your network settings, refer to Chapter 4: System
Management > Network

Step 2: RAID Creation

Basically, the RAID volume creation will be complete while Setup Wizard been operated. For
the RAID volume management, you can access RAID settings from the menu bar of the Web
Administration Interface by navigating to Storage > RAID.
For more information on RAID management, see Chapter 4: System Management >
RAID Configuration.
Don't know which RAID level to use? Find out more about the different RAID levels from
Appendix C: RAID

Step 3: Create Local Users or Setup Authentication

Once the RAID is ready, you can begin to create local users for the N0204 miniNAS, or
choose to setup authentication protocols.
USB 2.0 Copy
Button/LED
Management.
Basics.
Interface.
17 17