Mounting /Area Of Usage; Mounting And Connecting Tips - XTZ 99.26 MKII User Manual

Mounting and Connecting tips

Mounting
alternatives
Connect using the
correct phase
Overload
The initial playing
time
Normally the XTZ 99.26 MKII is placed standing
by a wall. The wall behind and besides the
loudspeaker have influence both on the bass level
and the bass characteristics, so please be patient
and try different distances to the rear and side
walls.
Always connect using the correct phase, from the
+-pole on the amplifier to the +-pole on the
loudspeaker and corresponding for minus (-).
At high load during extensive time periods, there is
always the risk of overloading the driver and
amplifier.
It takes about 50 to 100 hour of initial playing time
for the driver to sound optimal. During this time,
the speaker may be used normally.
Page: 8
If you by accident connect the other way,
there is no risk of damage. However, the
sound will not be correct, especially in the
lower frequencies.
All loudspeakers have a limited power
capacity, so be careful not to play
extremely loud and not to increase treble
or bass settings to much.