Table of Contents
Advertisement
8.2.2
PTZ SETUP
Pan / Tilt Setup allows you to set the PTZ Protocol for your PTZ enabled camera and configure settings such as travel
speed, dwell time, Port Settings, and Address Settings.
1
Use PTZ
2
Preset
3
Swing
4
Port Setting
5
Address Setting
6
Pan Speed
Tilt Speed
Zoom Speed
Focus Speed
7
On Screen Control
8
Pan/Tilt Type
8–3
Enables or disables PTZ control.
Set, Clear, and Create Presets and Preset Sequences. (Note: Most preset sequences
are controlled by dome)
This option enables the Horizontal (Pan) or Vertical (Tilt) 'Guard Tours'. (Note: Only
available in with certain domes/protocols)
Defines the specific settings to transmit to the PTZ data.
PTZ driver address must match that of the dome. Rx address only used on select dome
cameras.
Increases or decreases the Pan speed.
Increases or decreases the Tilt speed.
Increases or decreases the Zoom speed.
Increases or decreases the Focus speed.
Provides on screen control of a PTZ camera using the mouse.
Selects the protocol to use for the selected camera. The protocol is the unique set of
instructions that allows the Fusion Streamer to communicate with the PTZ camera.
Advertisement
Table of Contents
