Table of Contents
Advertisement
4
Power the Fusion Streamer off and then back on. Follow the instructions in Section 4.1 for connecting for the 1st time.
CAUTION: Any remote computers recording or receiving video data from the Fusion Streamer will lose their connection
when the unit is shut down.
4.8
UPGRADING THE VIDEO SERVER
Keeping your Streamer Software upgraded is important, this ensures that the Streamer Unit is operating at its peak
performance at all times. There are three basic ways to upgrade your Streamers Kernel, Server, and/or Web Viewer,
via the VSFinder software, the VSRemote software, or via the Web Viewer software.
Note: When upgrading the Kernel Module, the Streamer Unit may pause, this is a normal process.
1
VSFINDER (OPTION)
1. Run VSFinder
2. Select a Network Adapter and click OK
3. Click Find
4. Select the desired video server and either click Upgrade or Upgrade All
5. Select the Upgrade you wish to do, Kernnel, Server, and/or WebViewer and click Browse
6. Find the upgrade file and click Open
7. Click Upgrade
8. Click OK
2
VSREMOTE and WEBVIEWER (OPTION)
1. Run the Fusion Remote Software or Connect to your Streamer unit via WebViewer
2. Click the Setup Button
3. Click the VS Site Information Tab
4. To select the desired upgrade file (Kernel, Server, Web Viewer), use the browse button to locate updated .rom files
on the local PC
Note: Kernel Server and Web Viewer must be updated independently
5. Click the Upgrade button
6. Reboot the Streamer unit by clicking the Reboot Server button
7. Click the Close button to exit
4–4
Advertisement
Table of Contents
