Glass - HearthStone Heritage 8021 Owner's Manual

GLASS: 58" (140 cm) Length, 1/4" (.64 cm) Diameter,
Low Density Black Tube
ASH DOOR: 35" (89 cm) Length, 3/8" (9.5 mm)
Diameter, Low Density, Black Tube
SIDE DOOR: 46" (117 cm) Length, 3/8" (9.5 mm)
Diameter, Low Density, Black Tube
G
LASS
Do not operate the stove with a broken door glass. Do not
abuse the front door by striking or slamming.
When necessary, the glass can be cleaned with low alkaline
content commercial stove glass cleaners, which are
available from your local dealer. Never attempt to clean the
glass while the fire is burning or the glass is hot. Most
deposits can be cleaned by following the instructions
provided with the cleaner. To clean heavier deposits, open
the door and lift it straight up and off the stove with the
hinge pins remaining in the door (take care to save hinge
pins and washers for reuse). Lay the door face down on a
workbench or table, with the handle hanging off the edge so
it will lay flat. Apply the cleaner to the glass and allow it to
set for a few minutes. By laying the door flat, it will allow
the cleaner to penetrate rather than running off the surface
of the glass. Wipe the cleaner off with a soft cloth, or black
& white newsprint.
Important: scratching or etching the glass will
weaken the integrity of the glass. Do not use a razor
blade, steel wool, or any other abrasive material to
clean the glass. Use low alkaline content cleaners
only.
The front door glass is a ceramic, shock-resistant glass,
made specifically for use in woodstoves. Do not use any
replacement glass other than the ceramic glass
manufactured and supplied for use in this woodstove.
Replacement glass is available through your local dealer.
The door glass should be replaced immediately if broken or
chipped. Contact your local dealer for replacement glass,
which is accompanied with instructions and everything
needed for the repair. If you replace the glass yourself,
wear work gloves and safety glasses.
The procedure for glass and glass gasket replacement is as
follows:
1. Remove the door by lifting it straight up off the
hinges with the hinge pins remaining in the door.
2. Place the door face down on a flat, smooth surface,
other than the floor, with the handle hanging over
the edge.
HearthStone Quality Home Heating Products Inc ®
S C R E W
G L A S S
C L IP
P A D
3. Apply penetrating oil to the screws in the glass
retainer clips. Remove the screws to separate the
glass from the door.
4. Carefully lift the damaged glass and/or old gasket
from the doorframe and discard.
5. Peel the paper backing from the tape gasket.
Apply the new gasket to the doorframe as
illustrated on page 17.
6. Place the gasketed glass onto the door. Place a
new clip and gasket square around the glass, and
over the screw holes in the clip.
7. Screw the glass retainer clips (6) back on the door.
8. Install the door.
20
3 /8 " R O P E
G A S K E T
G L A S S C L IP
G L A S S
1 /4 " R O P E
G A S K E T
D O O R
Heritage Model 8021