No Mouse Pointer Displayed On The Screen - Fujitsu ESPRIMO Q900 Operating Manual

Cause
Wrong monitor has been set under
Windows XP
Wrong monitor has been set under
Windows 7

No mouse pointer displayed on the screen

Cause
The mouse is not correctly
connected.
Fujitsu Technology Solutions
Troubleshooting
► Restart the device.
► Press F8 while the system is booting.
Either the Windows Advanced Start Options menu or the
menu for selecting the operating system appears.
► If the menu for selecting the operating system
appears, press F8 .
► Select Safe Mode or Safe Mode with Network.
► Set the correct values for the attached monitor as
described in the operating manual of the monitor by
selecting Start - Settings - Control Panel - Display and
then the Appearance, Themes, Settings tabs.
► Restart the device.
► Press F8 while the system is booting.
Either the Windows Advanced Start Options menu or the
menu for selecting the operating system appears.
► If the menu for selecting the operating system
appears, press F8 .
► Select Safe Mode or Safe Mode with Network.
► Select Start – Control Panel – Appearance and Themes
– Display to set the correct values for the connected
monitor, as explained in the monitor instructions.
Troubleshooting
► Shut down the operating system properly.
► Switch the device off.
► Check that the mouse cable is properly connected
to the system unit.
If you use an adapter or extension lead with the
mouse cable, check the connections.
► Make sure that only one mouse is connected.
► Switch the device on.
Troubleshooting and tips
29