Table of Contents
Advertisement
5.
Then, mount the main unit onto the bracket.
Align the marking hole of the main unit with the <CAMERA FRONT> label of the
bracket, and turn the unit in the <LOCK> direction.
6.
Finally, install the cover back to the main unit.
Fit the protruding part inside the cover into the corresponding hole of the main unit, and
press the cover until you hear a click.
Adjusting the monitoring direction for the camera
Tilting
❖
Adjusting the monitoring direction
You can adjust the camera direction only when the camera is fixed on the ceiling.
Then, turning the camera to the left or right is referred to as "Panning", while tilting the
angle is "Tilting". For panning, the panning limit is 220° for the clockwise, and 100° for the
counterclockwise, a total of 255° enabled; further rotation is stopped by the stopper.
-
If you want to adjust the panning, loose the left/right screws (x2) on the bottom and
move the camera in a desired direction. Then, fix the camera in that position.
-
Adjust the tilting angle according to the vertical position. Note that panning within 17°
degrees may cause cutting some part of the monitoring object.
-
When you finish adjusting the tilt, tighten the tilt adjustable screw if you want to fix the
position.
J
For smoother Rotate adjustment, set the Tilt position between 60° ~ 80°.
Panning
English _19
Advertisement
Table of Contents
