MK Diamond Products MK-100 SERIES Owner's Manual & Operating Instructions page 21

SETUP, ADJUSTMENT and OPERATION
4. Off-angle Cutting:
NOTE: To cut angles other than 45º angles or Miters, a 90º Protractor (MK Diamond Part No. 134569-MK)
should be used.
DO NOT FORCE THE TOOL. It will do the job better and safer at the rate for which it was designed.
Turn counter- Adjustable
clockwise to loosen
Cutting Guide
Ruler/Stop
(A)
Remove the Adjustable Cutting
Guide
Turn Clockwise
to tighten
(D)
Position the 90º Protractor
and tighten the
retaining thumbscrew
Cooling Flow
Points
(F)
Verify proper cooling flow on
both sides of the blade (See
Maintenance Section to
increase/decrease flow)
MK-100
Turn counter-
clockwise to loosen
(B)
Place the 90º Protractor on
the Ruler/Stop
(D)
Position the tile against the 90º
Protractor and the Ruler/Stop
Hold Work
in Position
Direction
of Cut
(G)
Perform the cut
Revision 06/05, Effective Date June 07, 2005
Align Guide
to Ruler/Stop
Ruler/Stop
Set Angle
Set the desired angle and
tighten the thumbscrew
ON/OFF
Protractor
Switch
Ruler/Stop
ON/OFF
Switch
Turn the motor OFF when
Turn Clockwise
to tighten
(C)
On
Position
(E)
Turn the motor ON
Off
Position
(H)
work is complete
Page 21