Appendix C: BACnet GW-3 Local Configuration
NOTE: This procedure is only necessary if you are configuring an BACnet GW-3 using a
Configuration computer that is not already on the same IP network as the BACnet GW-3. Refer to
"Connecting BACnet GW-3 to an IP Network" on page
NOTE: A direct connection requires that a cross over Ethernet cable to be made or purchased
by the customer.
C.1 Direct Connection to the Gateway Board
Step 1. Connect the cross over cable between the configuration computer network card's Ethernet
Step 2. You have completed the connections, proceed to
Cross Over Cable Specifications
This cross over cable will be directly connected between the configuration computer network card
Ethernet connector and the BACnet GW-3 board Ethernet connector.
BACnet Gateway-3 Installation and Operation Manual - P/N: 53372:Rev: A 5/6/09
connector and the BACnet GW-3 board's Ethernet connector (refer to
Specifications").
Ethernet
Connector (J8)
Figure C.1 Configuration Computer Direct Connection
into the Configuration PC" on page
23.
PNET-1
"Add the IP Subnet of the BACnet GW-3
28.
"Cross Over Cable
To Configuration Computer
Customer Supplied Cable
49