6: Configure The Bacnet Gw-3 - Notifier BACnet GW-3 Installation And Operation Manual

BACnet GW-3 Configuration and Operation
Step 4. Type the default password, 00000000, and then click OK.
3.1.6 Configure the BACnet GW-3
Set Up the SNTP Server
NOTE: By default, the BACnet GW-3 synchronizes its internal clock with the NFN network time,
or with the Fire Alarm Control Panel in the case of a direct connection. Configuring the SNTP
server is only necessary if you want the gateway to synchronize with another server, such as an
ONYXWorks
Step 1. In the left pane of the BACNet Gateway Configuration Tool under the Gateway heading,
Step 2. Click the SNTP Server Address field under the Value heading, and then type the address
Configure Time Zone Settings
Step 1. In the left pane of the BACNet Gateway Configuration Tool under the Gateway heading,
Step 2. Use the fields under the Value heading to enter your local Greenwich Mean Time offset
28
Synchronizing with an SNTP server allows the BACnet GW-3 to keep accurate time.
®
Workstation or an SNTP time server.
click SNTP Configuration.
of the SNTP server.
click Time Zone Configuration.
value as well as the appropriate information about the observance of Daylight Savings
Time.
BACnet Gateway-3 Installation and Operation Manual - P/N: 53372:Rev: A 5/6/09
BACnet GW-3 Configuration