Access Control - Air Live WL-5460AP v2 User Manual

Access Control

When Enable Wireless A
addresses listed in the ac
entries with this functi
Wireless Access
Control Mode
MAC Address
Comment
Apply Changes
Reset
Delete Selected
Delete All
Reset
ccess Control is checked, only those clients whose wireless MAC
cess control list can access this Access Point.
on b eing enabled, then no clients will be able to access this Access Point.
Select the Access Control Mode from the pull-down menu.
Disab le: Select to disable Wireless Access Control Mode.
Allow Listed: Only the stations shown in the table can associate
AP.
Deny Listed: Stations shown in the table won't be able to associate w
the AP.
Enter the MAC Address of a statio
Point.
You m ay enter up to 20 characters as a remark to
Address.
Press to save the new
Press to discard the data you have entered since last time you press Apply
Change.
To delete clients from access to this Access Point, you may firstly check the
Select checkbox next to the MAC address and Comments, and press
Delete Selected.
To delete all the clients from access to this Access Point, just press Delete
All without selecting the checkbox.
If you have made any selection, press Reset will clear all the select mark.
n that is allowed to access this Access
settings on the screen.
29
If the list contains no
with the
the previous MAC
WL5460AP v2 User's Manual
ith