Air Live WL-5460 Manual

Restore from a firmware crash

Restore the WL-5460/WL-5450AP from a

The WL-5460/WL-5450AP features emergency firmware upgrade function that

can restore your AP from a firmware crashed. If you can't access your AP

anymore, please first try to restore the setting to default by holding the RESET

button (in the back) for more than 5 seconds. You should be able to find the AP

at 192.168.100.252. If you can't find it and the status LED stays RED after

power-on for 10 minutes. Then you can try the emergency upgrade method.

Section 1: Restoring AP with Emergency Code Function

Connect the Ethernet cable exactly to LAN 1 port of WL-5460/WL-5450AP v2.

Connect the other end of cable

Right click on "Network" -> "Properties" -> "Internet protocol (TCP/IP)

properties" on computer.

Assign fixed IP of 192.168.1.100/255.255.255.0 scope onto PC.

firmware crash

Status LED

DIRECTLY

to the PC.

Table of Contents

Need help?

Do you have a question about the WL-5460 and is the answer not in the manual?

Page 1 192.168.100.252. If you can’t find it and the status LED stays RED after power-on for 10 minutes. Then you can try the emergency upgrade method. Section 1: Restoring AP with Emergency Code Function Connect the Ethernet cable exactly to LAN 1 port of WL-5460/WL-5450AP v2. Connect the other end of cable DIRECTLY to the PC.
Page 2 Fig. 1-2, Assign IP as 192.168.1.100/255.255.255.0 onto your computer Reboot the WL-5460/WL-5450AP device while pressing and holding the “Reset” button of WL-5460/WL-5450AP, connect WL-5460/WL-5450AP to its power supply. Shown as fig 1-3. Fig 1-3, Hardware rebooting for upgrade Bootloader Keep holding the Reset button until the red light of the Status LED goes...
Page 3 Fig 1-4. Red LED turn off after 2~3 seconds Open a browser; type “192.168.1.6” at the URL, the display page is as graphic below(Fig 2-4) Fig. 2-4, Bootloader Emergency Code page Click the “browse” button, select and open the firmware file for your AP (download from www.airlive.com support section, do not use the wrong...
Page 4 Fig. 2-5, Assign IP as 192.168.100.100/255.255.255.0 onto your computer 10. Open a browser, type “192.168.100.252” at the URL, the page shows WL-5460/WL-5450AP management Web UI. Continue your configuration once this page appears. (Fig 2-6) Fig. 2-6, Normal Bootup Web Management UI...

Wl-5450ap