Programmable Features - RAM Chassis Cab 3500 User Manual

ELECTRONICS

PROGRAMMABLE FEATURES

Electronic Vehicle Information Center (EVIC) – If Equipped
• The EVIC can be used to program the following Personal Settings. Press the
UP or DOWN
SELECT button
button. Press the SELECT button to change the setting.
• Select Language
• Nav-Turn By Turn
• Auto Door Locks
• Auto Unlock Doors
• Remote Unlock Sequence
• RKE Linked To Memory
• Remote Start Comfort Sys.
• Horn With Remote Start
• Horn With Remote Lock
• Flash Lamps With Lock
Key Fob Programmable Features
• The following features may also be programmed by using the Key Fob
transmitter or the ignition switch and driver's door lock switch.
NOTE: Pressing the LOCK button while you are inside the vehicle will activate the
Vehicle Security Alarm. Opening a door with the Vehicle Security Alarm activated
will cause the alarm to sound. Press the UNLOCK button to deactivate the Vehicle
Security Alarm.
Unlock On First Press
• To unlock either the driver's side, or all doors, on the first press of the
UNLOCK button:
• Press and hold the LOCK button for at least 4 seconds, but no longer than
10 seconds. Then, press and hold the UNLOCK button while still holding the
LOCK button.
• Release both buttons at the same time.
Auto Unlock Doors On Exit
• To have all of the vehicle doors unlock when any door is opened:
• Enter your vehicle, close all the doors and fasten your seat belt.
• Within 15 seconds, cycle the ignition switch from the OFF position to the ON
position a minimum of four times, ending in the OFF position (do not start
the engine).
• Within 30 seconds, press the driver's door lock switch in the UNLOCK
direction. A single chime will indicate that programming is complete.
42
button until SYSTEM SETUP displays, then press the
. Scroll through the settings using the UP or DOWN
• Headlamp Off Delay
• Headlamps With Wipers
• Wiper Mode – If Equipped
• Easy Exit Seat – If Equipped
• Tilt Mirror In Reverse
• Key-Off Power Delay
• Illuminated Approach
• Compass Variance
• Calibrate Compass