Diesel Engine Starting Procedures - RAM Chassis Cab 3500 User Manual

Do not place any article under the adjustable pedals or impede its ability to
move, as it may cause damage to the pedal controls. Pedal travel may
become limited if movement is stopped by an obstruction in the adjustable
pedal's path.
• Tilting the steering column while the vehicle is moving is dangerous.
Without a stable steering column, you could lose control of the vehicle
and have a collision. Adjust the column only while the vehicle is stopped.
Be sure it is locked before driving.
• Do not adjust the pedals while the vehicle is moving. You could lose
control and have a collision. Always adjust the pedals while the vehicle is
parked.

DIESEL ENGINE STARTING PROCEDURES

Engine Block Heater
• For ambient temperatures below 0°F (-18°C), engine block heater usage is
recommended.
• For ambient temperatures below –20°F (-29°C), engine block heater usage is
required.
• The engine block heater cord is routed under the hood to the right side and
can be located just behind the grille near the headlamp.
• Connect the heater cord to a ground-fault interrupter protected 110–115 volt
AC electrical outlet with a grounded, three-wire extension cord.
NOTE: The block heater will require 110 volts AC and 6.5 amps to activate the
heater element.
• The block heater must be plugged in at least one hour to have an adequate
warming effect on the coolant.
Water In Fuel Message
• If a Water In Fuel message or
chime sounds five times, the fuel/water separator will need to be drained
immediately to prevent engine damage.
• Refer to Maintaining Your Vehicle in this guide for draining instructions or see
your dealer.
GETTING STARTED
CAUTION!
WARNING!
indicator appears in the cluster and a
19