Maxview MXL020HD Operating Manual page 46

In case of digital satellite reception, the receiver receives the transmission signal with a
time lag. Therefore, turn the antenna very slowly and step by step.
Step 5
As soon as you have found the
selected satellite, you will see
the programme list of the set
satellite on the screen and also
the sound will be transmitted.
The installation via the Easy
Find LNB is completed.
The current channel will be
displayed.
The Easy Find function is deselected by pressing the red function key. Signal strength and
quality are displayed again.
Now, optimise the antenna direction until you have reached the maximum value on the
signal-quality bar. The value may vary according to the situation, weather and signal
strength. However, you should reach a minimum of 60%. Exit the menu now by pressing
the "EXIT" key of your remote control.
Step 6
Please check once again if you are receiving the programme selected on the receiver. Press
the OK key of the remote control and then the 1 key. You will see the general channel list
"All satellites". Now, check also if you can receive further channels of the set satellite.
The installation process is complete.
Page 46
MXL020HD INSTRUCTIONS REVISION.indd 46 15/05/2013 14:12