Maxview MXL020HD Operating Manual page 44

Depending on which satellite you wish to receive, there must be free sight without any
obstacles at this angle.
After having made all relevant connections you can now start with the setup of the
antenna. Please check again that the receiver is connected with the Easy Find LNB at the
antenna and the receiver with your TV set. As soon as these cable connections have been
made correctly, you can switch on the devices.
Step 1
Switch on your TV set. Please make sure that your TV set has been adjusted to the receiver.
In case of a Scart connection, the TV set must be set to the correct AV channel. In case of
HDMI connections, the TV set must be switched over to HDMI.
Step 2
Switch on the receiver. As the antenna has
not been directed yet, the following image will
appear on your TV set:
Step 3
Now, you can begin to make the correct settings
for your receiver so that then you will be able to
direct the antenna with the
Easy Find LNB. Please proceed as follows:
Press the OK key of the remote control of your receiver to be able to see the TV channel list.
Now, press the INFO key of the remote control of your receiver twice.
The following will be displayed:
Press the red function key to enable the Easy Find function.
Now, you can go to your antenna to direct it. You will note that the LED on your Easy Find
LNB has begun to flash. This means, it is active. Now, the antenna can be directed to the
selected satellite.
Page 44
MXL020HD INSTRUCTIONS REVISION.indd 44 15/05/2013 14:12