Related Manuals for Maxview MXL007
Summary of Contents for Maxview MXL007
- Page 1 MXL007 (single LNB output) MXL007/TWIN (twin LNB output) Max-Dome Satellite System Installation & Operation Instruction Manual 9111407 issue 2...
- Page 2 All instructions and models are subject to change. In accordance with policy of progressive product, the company reserve the right to alter specifications. Copyright© these instructions are the sole property of Maxview Ltd and may not be reproduced. Please keep these instructions safe for future reference.
-
Page 3: Table Of Contents
Contents Warranty ..........................4 Safety Precaution ......................5 Introduction ........................6 Proper Use & Operation ....................6 System Components ......................7 Control Box Connections & Features ................. 7 Product Contents ....................... 7 Installation ......................... 8 Selecting an Installation Location ................... 8 Installation on the Vehicle .................... -
Page 4: Warranty
Should any trouble develop during the warranty period please contact Maxview before the warranty period expires. If you do experience a problem with the product contact Maxview Customer Services on (01553) 811000 or email cust_serv@maxview.co.uk. Please make sure you have the following ready when you call:... -
Page 5: Safety Precaution
Do not allow children to operate the antenna unit. Servicing If in the event that you do experience a problem with the system call Maxview Customer Service +44 (0)1553 811000. Any inspection or repair must be carried out by Maxview or an appointed representative of the manufacturer. -
Page 6: Introduction
Please read these instructions fully before using the antenna for the first time. The operation of the antenna has been designed to be as simple as possible however should you require any technical assistance please contact Maxview customer service on +44 (0)1553 811000 or visit www.maxview.co.uk. -
Page 7: System Components
Product Contents Dome Antenna Unit Control Box 1.5m Power Cable 1 x 5m Coaxial Cable with Cable Entry cover attached (MXL007 model) 2 x 5m Coaxial Cable with Cable Entry cover attached (MXL007/TWIN model) 1m Coaxial Flylead Instruction Manual Installation Pack(cable clips, screws) -
Page 8: Installation
Material construction and thickness is suitable for fixings. Installation on the Vehicle Position the Maxview Dome on top of the vehicle carefully in your chosen location. The ‘F’ connector should be directed to the rear of the vehicle. Follow the adhesive manufacturer’s guidelines for surface preparation. -
Page 9: Electrical Installation
Attach the ‘F’ connector to the Max-Dome Antenna ‘F ‘connection marked CONTROL BOX (on the MXL007/TWIN variant). Check for cables within roof space before drilling. Drill a hole through the roof and push cable into vehicle. -
Page 10: Operating The System
Operating the System Turning on the System Follow the steps below to turn on your Maxview Max-Dome. 1. Make sure the antenna has a clear view of the sky. 2. Turn on your Satellite Receiver and TV. 3. Turn the Control Box power to the ‘ON’ position. -
Page 11: Skew Adjustment
1. Using a crosshead screwdriver remove the dome cover. 2. Loosen the LNB clamp and rotate the LNB to the desired angle 3. Tighten LNB clamp and replace dome cover Note Maxview recommends that only competent installers perform this operation. ASTRA 28.2 Skew Map... -
Page 12: Troubleshooting
Troubleshooting If you have a problem with your unit, before contacting the technical service, check the following: Is everything turned on and connected properly? Make sure your TV and Receiver are both turned on and set up for the satellite input. Finally, check any connecting cables to ensure none have come loose. -
Page 13: Specification
Specification Model MXL007 MXL007/TWIN Antenna Type Parabolic off-set Parabolic off-set Frequency Band Ku Band Ku Band Dome Dimension for 40cm H x 70cm Ø 40cm H x 70cm Ø Installation Output Single LNB Twin LNB Antenna Dome Weight 9.5kg 9.5kg... - Page 14 Notes...